Update to Kona Gateway Default MQTT Credentials

Newer gateways coming out of the factory have had their default MQTT credentials updated to use randomized character strings to increase security.  These new default credentials can be found under the MQTT/OAM/Geolocation SERVER CREDENTIALS section of the test report sheet that is provided with your gateway. An example of this test report can be found below:

Older gateways will continue to use the old default MQTT Credentials below:

USERNAME: TEKXXYYZZ (Where XXYYZZ is the last 6 digits of the gateway ID)

PASSWORD: 9 Character Serial Number found on the gateway label (i.e. 1212A3434)

• Related Articles

• Kona Gateway Cellular Backhaul FAQ

  This article applies to Kona Gateways with cellular backhaul featured. You can find gateway specific FAQs here: Kona Micro / Micro PoE Kona Enterprise Kona Macro Kona Mega General FAQ Cellular Backhaul FAQ (you are here) Network Monitoring FAQ ...

• Tektelic MQTT Bridge Installation and Configuration Guide

  Procedure to install and configure Tektelic MQTT Bridge

• Kona Gateway Network Monitoring FAQ

  This article applies to Kona Gateways with cellular backhaul featured. You can find gateway specific FAQs here: Kona Micro / Micro PoE Kona Enterprise Kona Macro Kona Mega General FAQ Cellular Backhaul FAQ Network Monitoring FAQ (you are here) ...

• LoRa MQTT Command Line Sensor Configuration

  This document will demonstrate how to send a configuration payload through command-line and MQTT.

• Kona Enterprise Gateway User Guide

  See attachment for the most current Kona Enterprise User Guide.